Propellers & Accessories * | Acme Weekend Saver Kit W/C-Clamp Puller

Always Have One Of These On Hand And Ready For When You Need It Because There Is Nothing Worse Than A Ruined Weekend Because You Weren’T Prepared With The Necessary Tools To Replace A Damaged Prop.

The Acme Weekend Saver Kit Includes A Padded Prop Carry Case (Fits Up To 15 Diameter Prop), C-Clamp Prop Puller, Needle Nose Pliers, Crescent Wrench, And Prop Hardware Kit.

What’S Included

• C-Clamp Prop Puller
• Needle Nose Pliers
• Crescent Wrench
• Replacement Nylock Nut, Key, And Cotter Pin
• Padded Soft-Side Carry Case For Spare Prop And Tools

The 1 , 1-1/8 , Spline Shaft Size Kit Includes A C-Clamp Puller And Hardware That Fits 1 , 1-1/8 , Spline Shaft Sizes, And A Carry Case That Fits Props Up To 15.5 In Diameter.

The 1-1/4 Shaft Size Kit Includes A C-Clamp Puller And Hardware That Fits 1-1/4 Shafts, And A Carry Case That Fits Props Up To 18 In Diameter.

Using A C-Clamp Prop Puller Is By Far The Quickest And Easiest Way To Remove An Inboard Boat Prop. Whether You Are In Your Driveway Or At The Boat Ramp, Remove Your Damaged Prop And Replace It With Your Backup Prop.

Acme C-Clamp Prop Puller Instructions

• Remove The Cotter Pin. Loosen The Prop Nut Two Turns (Do Not Remove The Nut). You Want Approximately 2 Full Threads Of Space Between The Nut And The Prop Hub.
• Back Out The Prop Puller Bolt To Allow For Installation Of The Puller. The Puller “Fingers” Slide Between The Forward End Of The Prop Hub And Aft End Of The Strut. The Puller Bolt Cap Is Positioned Over The End Of The Shaft Aft Of The Prop.
• Advance The Puller Bolt Clockwise (Tighten) With A Wrench. Do Not Over-Tighten. The Purpose Of Tightening Is Not To Break The Prop Free, But To Apply Ample Pressure On The End Of The Shaft And The Forward End Of The Prop Hub To Transfer The Shock, During Impact, With A Hammer. Do Not Use An Impact Wrench.
• Once The Puller Is Firmly In Place And The Puller Bolt Is Tightened Down, Hit The Puller On The End Opposite The Both, With A Hammer (It Is Also Possible To Hit The Head Of The Puller Bolt, But Hitting It On The Finger End Is Preferred, To Avoid Causing Damage To The Bolt, Cap, Or Bolt Thread). It May Be Necessary To Repeat Steps 3 & 4. The Hammer Impact And Harmonics Should Be Enough To Break The Prop Free From The Shaft Taper. Once Free, Remove The Nut, Prop, And Key (If Applicable)
• When Reinstalling The Propeller, A Very Light Film Of Grease Or Anti-Seize On The Shaft/Bore Taper Is Acceptable, But Do Not Over-Apply. Also, Do Not Over-Tighten The Prop Nut. Approximately 35 Foot-Pounds Is Sufficient.